back to the Dollhouse Workshop
  • This is a Miniature Display being wired with tapewire
    015.jpg
  • This is a Cirkit "small eyelet" and the Real Good Toys "EL-66".
    054.jpg
  • Solidwire, tapewire, and striplights are all connected in the same way
    056.jpg

  • 059.jpg
  • The striplight is attached to a 30 degree angled "Light Support". There is a flap of tapewire under the striplight and they are connected with eyelets - "+" to the copper!!!
    063.jpg
  • Use brads or double sticky carpet tape to hold the light support in place so you can remove it later
    067.jpg
  • Nailing the light support to the front frame (or taping it to the valence).
    071.jpg
  • The flap of tapewire is connected to the primary tapewire run, copper to copper, and blue to blue.
    079.jpg
  • tapewire hookup complete.  This is looking up at a valence (on the left) and a light support holding the striplight at the right angle to light up the room.
    081.jpg