|
This slideshow shows how to customize the middle landing rail for the 6803 Banister and Landing Rail pack when used on a Painted Lady
The Victorian Painted Lady takes two 6803 sets
Angle Cutting Diagram
Top-Floor Landing Assembly
Painted Lady Stair Assembly
Faux-Wood Stair Treads |
DHTMLGoodies.com
Assemble and paint the Stairs... Paint or stain the 6803 parts
IMG_5980D.jpg
DHTMLGoodies.com
The Liner is oversized by the width of the Stairhole Glueblock
IMG_5981D.jpg
DHTMLGoodies.com
I'll add another Baluster instead of the second Newel
IMG_5985D.jpg
DHTMLGoodies.com
The un-used Liner gives the hole spacing for another Baluster
IMG_5986D.jpg
DHTMLGoodies.com
lots of spinning, not much pushing - don't break the knife tip
IMG_5989D.jpg
DHTMLGoodies.com
The craft-knife-hole is tapered so I am tapering the dowel
IMG_5990D.jpg
DHTMLGoodies.com
The Newel lines up on the end and is offset as you see
IMG_5998D.jpg
DHTMLGoodies.com
Center and Straighten the Rail - let the glue dry
IMG_6005D.jpg
DHTMLGoodies.com
Test the Landing Rail with the Stairs in place (top step lined up with the top of the floor)
IMG_6011D.jpg
DHTMLGoodies.com
The 'rise and run' of the stairs is 8+1/2" rise for 5+5/8" run
IMG_6009D.jpg
DHTMLGoodies.com
Mine lined up at the dowel, but mark yours in place to be sure
IMG_6015D.jpg
DHTMLGoodies.com
Gluing the stair balusters to the stairs and lip of the next step up
IMG_6025D.jpg
DHTMLGoodies.com
the Balusters are a fat 1/8" in from the edge - I cut the top dowels to fit
IMG_6028D.jpg
DHTMLGoodies.com
The upper Banister and Landings follow the instructions but with the Newel on the step
IMG_6032D.jpg
|
