Real Good Toys | |||||
| Painting the Alison Jr |
||||
Supplies: | |||||
Paint: [See the Paint-Color worksheet] |
Sandpaper: very fine sandpaper (at least 3 sheets) and |
||||
Preparation: | |||||
Protect the work surface: cardboard, newspapers, but wax your table first to help protect from paint accidents Protect your hands: latex gloves or petroleum jelly and talcum powder These parts take a large area to spread out for painting and drying; make sure you have enough space! A word about primer: Primer is designed to help paint stick to an impervious surface or to join layers of dissimilar paints. The job of the first coat of paint in a dollhouse is to soak right into the wood and fill the grain - you could do that with primer, but its job of being an interface between different materials doesn’t apply here. In this application, primer just adds steps and expense. I don’t use it here and don’t suggest it. |
|||||
Painting | |||||
First coat [video] everything that will be painted in the finished house, inside and out. Don’t get paint on edges that will be glued, on the ends of posts or rails, or in the walls' grooves. Finish the Floors [here] Sand [video] everything that has been painted. Sand thoroughly until the surface is smooth and feels “soft”, and the paint is transparent with some of the wood showing through. Sand the clapboard with folded sandpaper, one clapboard course at a time. Assemble the walls and the lower floors (see "Housebody 1.. 2.. 3") Second coat all exterior parts. The second coat goes on smooth and creamy with enough paint so the brush doesn't make a scratchy sound while brushing out the paint but not so much that you leave puddles or drips. Sometimes a third coat is necessary or a bit of touch-up at the end of construction. Anywhere a part can be marked to leave an area with wood showing for the glue to grab should be marked very lightly, then painted to just cover the mark. Doing this leaves some wood for the glue to grab (glue doesn't stick to paint), but hides the edge of painting inside a joint... much cleaner than masking for a paint-edge. If two adjacent parts are the same color, assemble them first, then second-coat them together. When you must glue to a painted surface (like Porch Posts), scrape a hidden spot to expose some wood for the glue to grab. Interior: Second-coat the ceilings or anywhere paint will be used after the house construction. If you are wiring, do that first and cover the Tapewire with Liner Paper before painting. Scrape the edges of the ceilings and grooves. |
|||||
Wallpaper | Liner Paper | ||||
Windows | Door | ||||
Paint the Stairs | Faux-Wood Treads | ||||