Tower Roof

Mark the Roofs for shingling at 1" intervals Roof2_01_lg.png

Transfer the marks to one edge of all the roofs Roof2_02_lg.png

Extend the lines across the roofs Roof2_03_lg.png

The Upper Back Roof indexes at the top Roof2_04_lg.png

Tape the Roofs together lined up top-and-bottom Roof2_05_lg.png

Glue the Roofs together... Roof2_06_lg.png

... all but the Lower Back Roof (if you want to remove it) Roof2_07_lg.png

Fold together the set Roof2_08_lg.png

Tape Roof2_09_lg.png

Make sure it wraps to line up top-and-bottom Roof2_10_lg.png

More tape Roof2_11_lg.png

Check that it's flat on the table Roof2_12_lg.png

This 'flat' is the Right end of the Tower Ceiling Roof2_13_lg.png

The 'flat' is on the right, the Back is in back Roof2_14_lg.png

4600 only: fit the groove-fill (if you are removing the Lower-Back) Roof2_15_lg.png

Mark and cut Roof2_16_lg.png

Test it with the Roof before gluing it in Roof2_17_lg.png

Ready for shingles Roof2_18_lg.png

Do not glue the Tower Ceiling to the house Roof2_19_L.png

Back to the Main Page ../../Buttons/ClickHere.png